When you create a mask using a specific channel, is there any way that you can save that mask and then load that mask back in again at a later time? The save and load curves buttons don't seem to do this.
Thanks,
Richard
Question about masks
Masks are copied to the clipboard. They can be saved as a image I suppose; and they stay on the clipboard until they are replaced or cleared.
The reason saving them is not real solid is that if you crop or re-size the image in any way the mask no longer matches the image and would not work.
You can paste the mask into a Word Pad document if you like..
Greg
The reason saving them is not real solid is that if you crop or re-size the image in any way the mask no longer matches the image and would not work.
You can paste the mask into a Word Pad document if you like..
Greg
Return to “Curvemeister 101 - December 2010”
Who is online
Users browsing this forum: No registered users and 11 guests