Week 1 Example 3 Silver Balls

This is the Discussion Board for the March 2010 CM101 Class.
Post Reply
kessi
Posts: 210
Joined: Thu Sep 04, 2008 1:07 pm

Postby kessi » Sat Mar 13, 2010 7:05 pm

Hi,
I did this without the wizard, "yehaw".
One is done in Lab and one using RGB. I tried to bring out the colour of the water without, hopefully, losing detail.
The RGB is more colourful.

kessi
Attachments
c01s01-example3_lab-jpg
c01s01-example3_lab-jpg (999 Bytes) Viewed 7001 times
c01s01-example3_rgb-jpg
c01s01-example3_rgb-jpg (999 Bytes) Viewed 7001 times
ggroess
Posts: 5342
Joined: Wed May 24, 2006 2:15 am
Contact:
Contact ggroess

Postby ggroess » Sat Mar 13, 2010 10:10 pm

Both are well handled the LAB version could use a bit of the saturation slider applied.  It holds up well when you do that...

Great job on the detail control  here is a zoom of your details...
Greg
Attachments
screenshot001-jpg-90
screenshot001-jpg-90 (64.38 KiB) Viewed 7001 times
kessi
Posts: 210
Joined: Thu Sep 04, 2008 1:07 pm

Postby kessi » Sun Mar 14, 2010 4:55 am

Got a blank. Saturation slider in Lab?
ggroess
Posts: 5342
Joined: Wed May 24, 2006 2:15 am
Contact:
Contact ggroess

Postby ggroess » Sun Mar 14, 2010 4:04 pm

in the curves interface at the bottom of the screen when you are in LAB you will see a slider.  Move it to the right and color saturation jumps up...move it to the left and it drops off.  It moves the A and B channels equally so you do not get wild color shifts.  You need to have a solid neutral before you apply this little goodie...

Attachments
screenshot001-jpg-89
screenshot001-jpg-89 (138.43 KiB) Viewed 7001 times
screenshot002-jpg-66
screenshot002-jpg-66 (207.07 KiB) Viewed 7001 times
kessi
Posts: 210
Joined: Thu Sep 04, 2008 1:07 pm

Postby kessi » Sun Mar 14, 2010 4:51 pm

Aaaargh I should have known that.  :-[
Post Reply

Return to “Curvemeister 101 March 2010”

Who is online

Users browsing this forum: No registered users and 13 guests