Masked Lemurs
This was difficult for me. I still think there is too much yellow in the photo.
- Attachments
-
- capturemasked-lemurs-curves-web-jpg (999 Bytes) Viewed 13012 times
-
- masked-lemurs-jpg-lab-acv
- (999 Bytes) Not downloaded yet
-
- masked-lemurs-web-jpg (999 Bytes) Viewed 13012 times
I went to HSB, set a neutral, and moved the curves around until I was happier with it.
It is better?
JoAnn H
You can set a neutral...some of the fur is a good target...
- Attachments
-
- masked-lemurs-web-jpg-hsb-acv
- (66 Bytes) Downloaded 651 times
-
- 2nd-passmasked-lemurs-web-jpg (120.6 KiB) Viewed 13012 times
-
- capture_2nd-pass-lemurs-web-jpg (122.14 KiB) Viewed 13012 times
Here's my new little guys. They look much better. I did start over with SNH. That was a good move.
JoAnn H
JoAnn H
The real issue is the saturation of the colors...when you ramp it up everything gets overblown....With a good neutral you can crank in the color and it looks good.
Greg
- Attachments
-
- 2ndlemur-jpg-lab-acv
- (58 Bytes) Downloaded 603 times
-
- 2nd-lemurs-web-jpg (105.29 KiB) Viewed 13012 times
-
- 2ndcapturelemurcurves-web-jpg (91.88 KiB) Viewed 13012 times
So we should always start with SHN? I haven't been doing that but I can see where it would really help. Thanks for that tip.
JoAnn
JoAnn
SHN is always a good move...it is the basic building block for everything we do in CM...
esp. Neutral...When we hit man from mars it will be clear that "betting the image" is very important...as in you bet the image on the neutral....
Greg
Return to “Curvemeister 101 September 2009”
Who is online
Users browsing this forum: No registered users and 15 guests