Mike,
In the new build the highlight threshold is not responding. When I set a shadow I can get the threshold masking and move my point around but in Highlight I can set the point but nothing works. the curve does not respond to the highlight nor does the mask appear when I drag the point around.
Greg
Highlight Threshold not working.
It's even weirder than that...
I tried your three trys result and go the following:
first highlight normal point.
Second Highlight working highlight point.
Then went to the shadow....
first shadow point normal point.
Second Shadow working shadow point.
Further...
If you delete the highlight and try to set a new one; the process starts over 1st point fails second point results correctly
Same results for shadow...
XP system CS3 32 bit
It seems to be on both sides of the spectrum...
Greg
I tried your three trys result and go the following:
first highlight normal point.
Second Highlight working highlight point.
Then went to the shadow....
first shadow point normal point.
Second Shadow working shadow point.
Further...
If you delete the highlight and try to set a new one; the process starts over 1st point fails second point results correctly
Same results for shadow...
XP system CS3 32 bit
It seems to be on both sides of the spectrum...
Greg
Return to “Curvemeister 3 Beta”
Who is online
Users browsing this forum: No registered users and 5 guests