I've not used WGCMYK much, so I don't understand it very well, but there seems to be some sort of weirdness with it and the 2.4.0 beta CM. I have an image in Lab mode, flattened into a single layer. When I look at it in CM in Lab, RGB or HSB mode it looks as expected. See first screenshot below. However, when I switch to WGCMYK mode, it looks like the second screenshot below.
Is this expected? I've only seen it do this with 2.4.0 beta, and I'm sure I'd have remembered if I'd seen it do this during the class coursework.
Weirdness with 2.4.0 and WGCMYK
-
- Posts: 4927
- Joined: Fri Sep 20, 2013 8:29 pm
-
- Posts: 4927
- Joined: Fri Sep 20, 2013 8:29 pm
I have tried now , and it did not occured.
But, I have seen in my computerlife, much strange things.
It could be CM. It could not be good installed.
It could be the combination of CM and other plugins or PS.
There are a lot of possibilities.
So, Mike is always interested if it is a bug.
But it must be repoduced to do investigation
Frits
But, I have seen in my computerlife, much strange things.
It could be CM. It could not be good installed.
It could be the combination of CM and other plugins or PS.
There are a lot of possibilities.
So, Mike is always interested if it is a bug.
But it must be repoduced to do investigation
Frits
Return to “Curvemeister Support”
Who is online
Users browsing this forum: No registered users and 15 guests