Hello again
In this image I found that after a lot of experimentation that I could get detail in the sand but overall there was a red caste over the image. This is very noticeable in the parasol fronds and the sand.
I tried to remove it in Lab mode but removing the red caste in Lab brought back the blue caste that the original image had.
So I decided to tackle the red caste in RGB mode.
I thought that thisw was successfully done but now I notice that the deck chairs in the background are a bright cyan.
I would normally tone them down in a special layer.
Regards
Week 03, Example 04
This image is always a fight to the finish...
This is one where being subtle is the key..Fix the sand using the highlight threshold method. tackle the shadow on the chair and tweak the blues a bit...But too heavy of a hand here makes this image look garish..The cyan chairs is a good indicator that you have gone too far...
This is one where being subtle is the key..Fix the sand using the highlight threshold method. tackle the shadow on the chair and tweak the blues a bit...But too heavy of a hand here makes this image look garish..The cyan chairs is a good indicator that you have gone too far...
Return to “September 2007 Curvemeister 101”
Who is online
Users browsing this forum: No registered users and 1 guest