Page 1 of 1
Posted: Wed Jan 23, 2008 11:05 pm
by mikemeister_admin
I had a problem with this. The neutral escapes me. I ended up using the gravel bar in the front lower left. Obviously it is not correct, because there is still a cast. The floating neutrals I have to work on.
Posted: Thu Jan 24, 2008 4:24 am
by ggroess
Barry try the water in a white water area..It might give you a close approximation.
Posted: Thu Jan 24, 2008 7:59 pm
by mikemeister_admin
Greg
Putting the neutral in the white water area helped a lot. I considered the water the first time but thought it would probably be a dirty colour from the run off. This time I chose the white water as suggested in stead of the smooth grey water mixed in it. The was a slight variation in the results. Thank you for the suggestion.
Posted: Thu Jan 24, 2008 8:26 pm
by ggroess
Looks much better Barry....
You might even try bumping the saturation a bit just to see whats out there...your call though...
Greg