Page 1 of 1
Posted: Sun Aug 03, 2008 3:04 pm
by mikemeister_admin
I think because everything is so close together on the curves, this is impossible to get 'right' for every part of the image.
I've got 2 renditions
1st attempting to pin each face
Posted: Sun Aug 03, 2008 3:07 pm
by mikemeister_admin
2nd yellow warmer trying to get rid of the blue everywhere
I give up on this one!
Posted: Mon Aug 04, 2008 7:21 pm
by ggroess
You might have overworked this one...
I try to keep it simple. Set a Skin 8 pin as shown in the attached image and then set a neutral in the shadow. after that I just moved the skin 8 pin around a bit to get the other two faces reasonable.
If you wanted you could take a second pass at the image in LAB for saturation.
Gre