Page 1 of 1
Posted: Sat Mar 13, 2010 7:05 pm
by kessi
Hi,
I did this without the wizard, "yehaw".
One is done in Lab and one using RGB. I tried to bring out the colour of the water without, hopefully, losing detail.
The RGB is more colourful.
kessi
Posted: Sat Mar 13, 2010 10:10 pm
by ggroess
Both are well handled the LAB version could use a bit of the saturation slider applied. It holds up well when you do that...
Great job on the detail control here is a zoom of your details...
Greg
Posted: Sun Mar 14, 2010 4:55 am
by kessi
Got a blank. Saturation slider in Lab?
Posted: Sun Mar 14, 2010 4:04 pm
by ggroess
in the curves interface at the bottom of the screen when you are in LAB you will see a slider. Move it to the right and color saturation jumps up...move it to the left and it drops off. It moves the A and B channels equally so you do not get wild color shifts. You need to have a solid neutral before you apply this little goodie...
Posted: Sun Mar 14, 2010 4:51 pm
by kessi
Aaaargh I should have known that. :-[