Page 1 of 1
Posted: Fri Jan 14, 2011 12:23 pm
by mikemeister_admin
I have followed the instructions for using Curvemeister as a Smart Filter in Photoshop CS3. However when I double click on Curvemeister 3 in the Layers Palette, it takes me back to the original uncorrected image. If now cancel out of Curvemeister, I get the corrected image in Photoshop.
What am I doing wrong?
Richard
Posted: Fri Jan 14, 2011 6:58 pm
by ggroess
Click on the Word Curvemeister in the layer stack...
Did you check the scroll when you were in CM??
If you did those two things it should work well...
Greg
Posted: Fri Jan 14, 2011 7:18 pm
by mikemeister_admin
Yes, I clicked on the word Curvemeister in the layer stack.
What do you mean by checking the scroll in CM?
Thanks,
Richard
Posted: Fri Jan 14, 2011 8:53 pm
by ggroess
There is an Icon in CM that is circled in the screen shot below...
It tells CM to play nice with PS on a smart filter...
Unfortunately for this version of CM Mike had to make a few compromises to get this to work...
Greg
Posted: Sat Jan 15, 2011 11:35 am
by mikemeister_admin
Yes, it works if I click on the icon. I was wondering what the purpose of the icon was.
Does it have any use if you use CM in Photoshop Elements?
Thanks,
Richard
Posted: Sat Jan 15, 2011 8:25 pm
by ggroess
My understanding is it is only for smart filter....
Elements dose not have that ability
Greg