Page 1 of 1
Posted: Fri May 03, 2013 5:38 pm
by Daniel Zuck
K channel mask with GCR set to 100. Followed procedure set out in video. Used lightness channel to control mask blur. Added 2 extra pin in L curve to bring out detail in clouds
dan
Posted: Fri May 03, 2013 5:42 pm
by Daniel Zuck
without accidental erasures
dan
Posted: Sat May 04, 2013 3:07 pm
by ggroess
Hey Dan,
Two minor issues with this one.
Shot 1 shows the tree line. The noise might be coming from the mask so take a good look at it to see if you can eliminate some of the edge noise. try reducing the blur if you can. Also the image has a slight yellow cast to it...see screen shots below.
Greg