Curvemeister Forum

Mike,
First time I ran the program after install I got the attached Print screen and blown out of PSE.

I re-booted and got the program to run.

When I did get it to run I went to LAB and set a highlight. 
The threshold mask came on and hid the image except for the highlights but then but would not revert back until I set a shadow point. 
When I set the shadow CM3 placed it in the lower right corner of the image not where I set it and I had to move it to where I placed it. 
After the shadow was set the image returned to normal view and I was able to threshold the highlight with the correct behavior.

The Exception was on an XP workstation with SP2 applied.
Greg

Nice crash there, Greg.  I'll see what I can do as far as reproducing the problem on PSE6

So far I've been unable to reproduce the problem.  I'll keep at it.

BTW - I released version 3.0.3 about 2 hours ago.  If you've been using 3.0.2 see if you can get the problem to happen with the newer version.
http://curvemeister.com/downloads/cm3_beta/

In Vista I was able to load and open without re-boot. That was 3.0.3 with the crash...

The shadow and highlight pins worked correctly and everthing seems normal...
I'll see if I can break it for you....

Greg