Curvemeister Forum

I think Gloria might have mentioned this one, but in case I'm confusing her posts I'll report it:

I open an image and run CM3, which comes up in RGB mode. I use "Quick pin to original color" to set a point, then go to the blue curve (which now has just the one point on it) and click-drag on the blue curve's bottom margin. CM3 and PS disappear. No crash report, nothing.

Seems 100% reproducible for me.

Here is a dump file...from Dereks procedure...PSE6.0

Greg

Yes, this is a problem.  It is possible to "tangle" the curve for at least one combination of rotation. As of v.20 there should no longer be a crash.  Please let me know if you can still crash v.20.