Pin, rotate, gone

The Curvemeister 3 beta test. Please post and discuss bugs, screen shots, suggestions, and any other information about your testing. This board is only visible to Curvemeister 3 beta testers.
Post Reply
derekfountain
Posts: 251
Joined: Fri Jan 26, 2007 1:24 pm

Postby derekfountain » Wed Oct 17, 2007 6:51 pm

I think Gloria might have mentioned this one, but in case I'm confusing her posts I'll report it:

I open an image and run CM3, which comes up in RGB mode. I use "Quick pin to original color" to set a point, then go to the blue curve (which now has just the one point on it) and click-drag on the blue curve's bottom margin. CM3 and PS disappear. No crash report, nothing.

Seems 100% reproducible for me.
ggroess
Posts: 5342
Joined: Wed May 24, 2006 2:15 am
Contact:
Contact ggroess

Postby ggroess » Wed Oct 17, 2007 9:40 pm

Here is a dump file...from Dereks procedure...PSE6.0

Greg
-default
Posts: 1916
Joined: Thu Mar 26, 2015 1:53 am

Postby -default » Thu Oct 18, 2007 2:22 am

Yes, this is a problem.  It is possible to "tangle" the curve for at least one combination of rotation. As of v.20 there should no longer be a crash.  Please let me know if you can still crash v.20.
Post Reply

Return to “Curvemeister 3 Beta”

Who is online

Users browsing this forum: No registered users and 4 guests