master curve window

[mikemeister_admin]

Mike, I'm just wondering why the position of the cursor over the image isn't shown in the composite curve window. Not that it is necessary, but is there a reason?

[-default]

Now that you mention it, I did remove that feature from Curvemeister 3.  The traditional cursor on the RGB curve is misleading, because it reflects an average value for the three channels, which is misleading unless the object in question is gray.

I'll see about adding it back in, probably as several markers on the RGB master curve, one for each channel.

[mikemeister_admin]

Whoa, that never even occurred to me. I actually like looking at the other channels to decide if I'm going to make a master adjustment. This is a cool program. I'm learning a lot!